欢迎访问《图学学报》 分享到：
图学学报

图学学报

• 智能设计与数字化设计 • 上一篇    下一篇

基于Revit 的牵引变电设备BIM 模型与信息集成研究

  

  1. 1. 兰州交通大学电子与信息工程学院，甘肃兰州 730070；
    2. 甘肃省人工智能与图形图像处理工程研究中心，甘肃兰州 730070
  • 出版日期:2018-08-31 发布日期:2018-08-21
  • 基金资助:
    中国铁路总公司科技研究开发计划课题(2016X002)

BIM Model and Information Integration of Traction Substation Equipment Based on Revit

  1. 1. School of Electronic and Information Engineering, Lanzhou Jiaotong University, Lanzhou Gansu 730070, China;
    2. Gansu Provincial Engineering Research Center for Artificial Intelligence and Graphics & Image Processing, Lanzhou Gansu 730070, China
  • Online:2018-08-31 Published:2018-08-21

PDF (PC)

270

摘要： 牵引变电设备在其生命周期内拥有大量异构的信息，然而以Autodesk Revit 为建
模软件建立牵引变电设备BIM 模型时，由于模型属性参数类型与参数分组方式有限，导致模型
无法满足对设备全生命周期信息集成的要求。本文针对上述问题，以牵引变压器为例，在分析
牵引变压器非几何信息并将信息进行分类分级的基础上，提出一种将牵引变压器非几何信息融
入设备BIM 模型使几何信息与非几何信息集成于同一Revit 文档的集成方法，并基于Revit API
开发插件对上述方法进行实现。结果表明该方法既实现了将设备几何信息与相对大量的非几何
信息集成于同一Revit 文档的目标，又保证了Revit 文档的轻量化，达到了预期目标。

关键词: Revit, 牵引变压器, 建筑信息模型, 信息集成

Abstract: Traction substation equipment in its life cycle has a large number of heterogeneous
information. However, when Autodesk Revit is used as modeling software to establish BIM model of
traction substation equipment, the model cannot meet the requirement of information integration for
the whole life cycle of the equipment due to the limited attribute parameter type and grouping mode.
Aimed at the above problems, this paper took traction transformer as an example, analysed the
non-geometric information of the traction transformer, then further classified and graded the
information, and finally proposed a new method which integrates the non-geometric information into
BIM model so as to combine both geometric and non-geometric information in the same Revit
document, and to facilitate the above methods, a plug-in module is developed using Revit API.
Experimental results have shown that the method can not only integrate the geometric information of
the equipment with a large number of non-geometric information in the same Revit document, but
also ensure the lightweight of the Revit document, and therefore achieve the desired objectives.

Key words: Revit, traction transformer, building information modeling, information integration